Punch Unit Installation (D570)
D129/D130 2-50 SM
This is the 3-pin connector.
14. Connect "Wire harness: short-circuit" [A] to the CN110 connector.
15. At the front, use a pair of wire cutters to remove the part [A] of the cover.
16. Install the punch-waste transport unit [B] in the finisher.
17. Make sure that the punch-waste transport unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with the grooves.
18. Remove the short connector from the connector [C].
To Next Page
Loading...
