8. Attach the slide drive unit [A] to the finisher and connect it to the punch unit (
x 2, x 1).
Push in the slide drive unit at
when you attach the screw .
9. Make sure that the punch unit moves freely and is not blocked by the screws.
10. Put the side-to-side detection unit [A] in the machine. Make sure that the two pins are
engaged correctly at the front.
11. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
12. Attach the side-to-side detection unit and connect it at the rear (
x 2, x 1, x 1).
13. Pull the short connector out of the connector [B], then connect the cable of the finisher (
x 1).
To Next Page
Loading...
