Bit Switches - 1
D702 64 SM
System Switch 0E (SP No. 1-101-015)
No Function Comments
2
Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
Direct sending cannot operate when the
capture function is on during sending. Setting
this switch to "1" enables direct sending
without capture.
Setting this switch to "0" masks the direct
sending function on the operation panel so
direct sending with ScanRouter cannot be
selected.
3
Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the same)
0: Manual tx is possible while the external
handset is off-hook. However, manual tx
during handset off-hook may not be sent to a
correct direction. Manual tx is not possible.
1: The display stays in standby mode even
when the external handset is used, so that
other people can use the machine for memory
tx operation. Note that manual tx and rx are
not possible with this setting.
System Switch 0F (SP No. 1-101-016)
No Function Comments
0
to
7
Country/area code for functional
settings (Hex)
This country/area code determines the
factory settings of bit switches and RAM
addresses. However, it has no effect on
the NCU parameter settings and
communication parameter RAM
addresses.
Cross reference
NCU country code:
SP No. 2-103-001 for G3-1
00: France 12: Asia
01: Germany 13: Japan
02: UK 14: Hong Kong
03: Italy 15: South Africa
04: Austria 16: Australia
05: Belgium 17: New Zealand
06: Denmark 18: Singapore
07: Finland 19: Malaysia
08: Ireland 1A: China
09: Norway 1B: Taiwan
0A: Sweden 1C: Korea
0B: Switz. 1D: Brazil
0C: Portugal 20: Turkey
To Next Page
Loading...
