Ricoh D158 - Page 908

Bit Switches - 1
D702 66 SM
System Switch 12 (SP No. 1-101-019)
No Function Comments
0-7
TTI printing position in the main
scan direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position
for the TTI from the left edge of the paper. If
the TTI is moved too far to the right, it may
overwrite the file number which is on the top
right of the page. On an A4 page, if the TTI is
moved over by more than 50 mm, it may
overwrite the page number.
System Switch 15 (SP No. 1-101-022)
No Function Comments
1
Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy
Saver mode quickly, because the +5V power
supply is active even in the Energy Saver
mode. The LED of the operation switch is
flashing instead of entering Energy Saver
mode.
Use this setting if an external telephone has to
be used when the machine is in the Energy
Saver mode.
4-5
Interval for preventing the
machine from entering Energy
Saver mode if there is a
pending transmission file.
If there is a file waiting for transmission, the
machine does not go to Energy Saver mode
during the selected period.
After transmitting the file, if there is no file
waiting for transmission, the machine goes to
the Energy Saver mode.
Bit 5 Bit 4 Setting
0 0 1 min
0 1 30 min
1 0 1 hour
1 1 24 hours