TYPE M1
(D702)
1
Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during
scanning for a memory transmission, the
successfully scanned pages are transmitted.
1: If the SAF memory becomes full during
scanning for a memory transmission, the file is
erased and no pages are transmitted.
This setting is effective only when
Automatic Journal printout is enabled
but the machine cannot print the
report (e.g., no paper).
2
RTI/CSI display priority
0: RTI 1: CSI
This bit determines which identifier, RTI or CSI,
is displayed on the LCD while the machine is
communicating in G3 non-standard mode.
3
File No. printing
0: Enabled
1: Disabled
1: File numbers are not printed on any reports.
The file numbers may not be printed
in the sequential order. If a customer
does not like this numbering, select
"0".
4
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: Faxes can be received if the
sender has an RTI or CSI
1: All fax reception is disabled
0: If the user has stored no acceptable sender
RTIs or CSIs, the user can select “ON” in the
authorized reception setting but the setting
becomes invalid (“OFF”). The machine will not
be able to receive any fax messages.
If the customer wishes to receive messages
from any sender that includes an RTI or CSI,
and to block messages from senders that do
not include an RTI or CSI, change this bit to
"0", then enable Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
To Next Page
Loading...
