TYPE M1
(D702)
7
Closed network (reception)
0: Disabled
1: Enabled
1: Reception will not go ahead if
the polling ID code of the remote
terminal does not match the polling
ID code of the local terminal. This
function is only available in
NSF/NSS mode.
Communication Switch 01 (SP No. 1-104-002)
No Function Comments
0
ECM
0: Off 1: On
If this bit is set to 0, ECM is switched off for all
communications.
In addition, V.8 protocol and JBIG compression
are switched off automatically.
2-3
Wrong connection prevention
method
(0,1): The machine will disconnect the line
without sending a fax message, if the last 8
digits of the received CSI do not match the last
8 digits of the dialed telephone number. This
does not work when manually dialed.
(1,0): The same as above, except that only the
last 4 digits are compared.
(1,1): The machine will disconnect the line
without sending a fax message, if the other
end does not identify itself with an RTI or CSI.
(0,0): Nothing is checked; transmission will
always go ahead.
This function does not work when
dialing is done from the external
telephone.
Bit 3 Bit 2 Setting
0 0 None
0 1 8 digit CSI
1 0 4 digit CSI
1 1 CSI/RTI
6-7
Maximum printable page length
available
The setting determined by these bits is
informed to the transmitting terminal in the
pre-message protocol exchange (in the
DIS/NSF frames).
Bit 7 Bit 6 Setting
0 0 No limit
0 1 B4 (364 mm)
1 0 A4 (297 mm)
1 1 Not used
To Next Page
Loading...
