Bit Switches - 3
D702 86 SM
Communication Switch 02 (SP No. 1-104-003)
No Function Comments
0
G3 Burst error threshold
0: Low 1: High
If there are more consecutive error lines in
the received page than the threshold, the
machine will send a negative response.
The Low and High threshold values
depend on the sub-scan resolution, and
are as follows.
100 dpi
6(L)
12(H)
200 dpi
12(L)
24(H)
300 dpi
18(L)
36(H)
400 dpi
24(L)
48(H)
1
Acceptable total error line ratio
0: 5% 1: 10%
If the error line ratio for a page exceeds the
acceptable ratio, RTN will be sent to the
other end.
2
Treatment of pages received with
errors during G3 reception
0: Deleted from memory without
printing
1: Printed
0: Pages received with errors are not
printed.
3
Hang-up decision when a negative
code (RTN or PIN) is received
during G3 immediate transmission
0: No hang-up, 1: Hang-up
0: The next page will be sent even if RTN
or PIN is received.
1: The machine will send DCN and hang
up if it receives RTN or PIN.
This bit is ignored for memory
transmissions or if ECM is being used.
Communication Switch 03 (SP No. 1-104-004)
No Function Comments
0-7
Maximum number of page
retransmissions in a G3
memory transmission
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
To Next Page
Loading...
