and Adjustment
4.12.6 BICU
1. Controller Board (page 4-58 "Controller Board")
2. BICU [A] ( x6, x all)
3. Remove the EEPROM [A] from the old board and install it on the new board.
Install so that the indentation [B] on EEPROM is facing the direction of the dent [C] that is
printed on the BICU board.
4. Install the new BICU in the machine.
5. Enter the BICU serial number.
If the BICU serial number is not entered correctly, SC995-01 (serial number entry
error) appears.
6. Turn the main power switch off and on.
7. Set the DIP switches on the new BICU board to the same settings as the old board.
Make sure the EEPROM is correctly installed on the BICU. Insert the EEPROM in the
EEPROM slot with the "half-moon" pointing [C] to the downside.
To Next Page
Loading...
