and Adjustment
4.14 SCANNER
Turn off the main power switch and disconnect the power cord before you start any of the
procedures in this section.
4.14.1 SCANNER UNIT (WITH ARDF)
When you want to detach only the ARDF, see page 4-73 "ARDF Unit".
1. Left Cover (page 4-7 "Left Cover")
2. Right Cover (page 4-8 "Right Cover")
3. Pulling the side of the operation panel lower cover [B], release the hooks of the
operation panel upper cover [A] and remove the covers. (Hook x4)
There are four tabs on the back of the front right cover [A]. Refer to the picture below
before the replacement. Release the tab [B] first when removing the front right cover.
To Next Page
Loading...
