Maintenance
Updating Procedure
1. Turn the main power switch off.
2. Remove the slot cover [A] ( × 1).
3. Insert the SD card into SD Card Slot 2 [B].
Make sure the label on the SD card faces the front side of the machine.
Slowly push the SD card into the slot so it locks in place. You will hear it click. Make
sure the SD card locks in place.
To remove the SD, push it in to unlock the spring lock. Then release it so it pops out
of the slot.
4. Disconnect the network cable if the machine is connected to a network.
5. Turn the main power switch on.
After a few seconds, the initial version update screen appears on the LCD in English.
6. If the SD card contains more than one software application, the screen will be almost
the same as the one below. The screen below shows that the SC card contains two
applications: "Engine" and "Printer".
7. To select the item for upgrade, touch the selection on the touch panel, or push the
corresponding key on the 10-key pad (1 to 5) of the operation panel. The number in
parentheses tells you which key to push. When you make a selection, the [Verify(./*)]
and [Update(#)] buttons come on the screen.
To Next Page
Loading...
