Maintenance
1
Press two times to leave the SP mode and return to the user screen to resume
normal operation.
2 Press any Class 1 number to open a list of Class 2 SP modes.
3 Press to scroll the show to the previous or next group.
4
Press to scroll to the previous or next display in segments the size of the screen
display (page).
5 Press to scroll the show the previous or next line (line by line).
6 Press to move the highlight on the left to the previous or next selection in the list.
5.1.5 SERVICE MODE LOCK/UNLOCK
At locations where the machine contains sensitive data, the customer engineer cannot operate
the machine until the Administrator turns the service mode lock off. This function makes sure that
work on the machine is always done with the permission of the Administrator.
1. If you cannot go into the SP mode, ask the Administrator to log in with the User Tool
and then set "Service Mode Lock" to OFF after he or she logs in:
User Tools > System Settings > Administrator Tools > Service Mode Lock > OFF
This unlocks the machine and lets you get access to all the SP codes.
The CE can service the machine and turn the machine off and on. It is not necessary to
ask the Administrator to log in again each time the machine is turned on.
2. Go into the SP mode and set SP5169 to "1" if you must use the printer bit switches.
3. After machine servicing is completed:
Change SP5169 from "1" to "0".
Turn the machine off and on. Tell the administrator that you have completed servicing the
machine.
The Administrator will then set the "Service Mode
Lock" to ON.
To Next Page
Loading...
