2.11.3 INSTALLATION PROCEDURE
Unplug the main machine power cord before you do the following procedure.
1. Loosen the screw and remove the SD card slot cover at an angle.
2. Insert the SD card (OCR Unit) in SD slot 2 (lower). Then push it slowly until it clicks.
3. Plug in the power cord, and then turn on the machine.
4. Go to SP 5-878-004 (Option Setup: OCR) and press [EXECUTE].
The SD card ID is recorded in NVRAM, and the machine ID of the main machine is recorded
in the SD card.
5. When the display tells you that the execution is completed, press [Exit].
If the execution failed, the display tells you that the execution failed.
If the execution failed, do the following.
Check if the SD card is already used.
Check whether the SD card has been used with another MFP (whether the OCR unit
in the SD card has been installed in another MFP).
Turn off the main power switch, and do steps 1 to 5 again.
6. Turn the main power switch off and on.
7. Go to SP 5-878-004 (Option Setup: OCR) and press [EXECUTE].
The OCR dictionary is copied to the HDD from the SD card.
To Next Page
Loading...
