Ricoh M160 - Registration Adjustment

Troubleshooting
M160/M161 6-114 SM
6.4.3 REGISTRATION ADJUSTMENT
Print Area
Check that the adjustment meets the product specification.
 [1]: Paper feed direction
 [2]: Print area
Adjustment Reference Values
 B: Leading edge (Sub scanning direction): 3.0 ± 1.5 mm
 D: Trailing edge (Sub scanning direction): 3.0 mm
 C: Left (Main scanning direction): 2.0 ± 1.5 mm
 A: Right (Main scanning direction): 2.0 mm
Adjustment Procedure
1. Enter the SP mode, and then print the test pattern (17: Trim Area) with SP2-109-001.
 Print the test pattern, and then adjust the leading edge registration in the SP mode to
the optimum value.
2. Do SP1-002-(001,002,003,004,006) to check and adjust the registration.
3. Check the side-to-side registration for each paper feed trays.