Ricoh M160 - Sc200 (Led Optics)

Service Call
SM 6-7 M160/M161
Troubleshooting
6.2.3 SC200 (LED OPTICS)
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC230-00 D
FGATE
*1
: Does not turn ON.
GPIO
*2
has not been asserted, although the specified time (200
ms) elapsed after setting JOB to be started and reaching the
FGAT assert time.
Control Board
Turn the main power OFF and then ON.
(*1)FGATE: Signals used between the controller and the engine in order to send the information
about the sub scan length of the page to be printed.
(*2)GPIO: A type of input/output terminal
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC231-00 D
FGATE
*1
: Does not turn OFF.
GPIO
*2
has not been negated, although the specified time (200
ms) elapsed after detecting GPIO*assert and then reaching the
expected FGATE negate time.
* This is an I/O pin. Such I/O pins can be used for a variety of
applications, depending on the setting.
 Control Board
 Engine Board
(*1)FGATE: Signals used between the controller and the engine in order to send the information
about the sub scan length of the page to be printed.
(*2)GPIO: A type of input/output terminal