Ricoh M160 - Service Program Mode; Service Table Key

Service Program Mode
SM Appendix 3-1 M160/M161
Appendices:
SP Mode Tables
3. APPENDICES: SP MODE TABLES
3.1 SERVICE PROGRAM MODE
3.1.1 SERVICE TABLE KEY
Notation What it means
[range / default / step]
Example: [-9 to +9 / 0 / 0.1 mm step]. The setting
can be adjusted in the range ±9, value reset to
+3.0 after an NVRAM reset, and the value can be
changed in 0.1 mm steps with each key press.
*
Value stored in NVRAM. After a RAM reset, this
default value (factory setting) is restored.
DFU
Denotes "Design or Factory Use". Do not change
this value.
Japan only
The feature or item is for Japan only. Do not
change this value.
SSP This denotes a "Special Service Program" mode.
FSP This denotes a "Factory Service Program" mode.