SP Mode Tables
3.13 TEST PATTERN PRINTING
3.13.1 TEST PATTERN PRINTING
Printing Test pattern: SP2-109
Some of these test patterns are used for copy image adjustments but most are used primarily for
design testing.
Do not operate the machine until the test pattern is printed out completely. Otherwise, an
SC occurs.
1. Enter the SP mode and select SP2-109-001.
2. Select the number for the test pattern that you want to print and press [OK].
3. Press the "Start" key to open the copy menu, then select the settings for the test print (paper
size etc.).
4. Press the "Start" key twice to start the test print.
5. After checking the test pattern, press [To SP] on the LCD to return to the SP mode.
6. Touch [Exit] three times to exit SP mode.
0 None 9 Arg. Grid20mm
1 Vert. (1dot) 10 Indep. (1dot)
2 Hori. (1dot) 11 Indep. (2dot)
3 Vert/ (2dot) 12 Indep. (4dot)
4 Hori. (2dot) 13 Full
5 Grid Vert. 14 Band
6 Grid Hori. 15 Gray 10mm
7 Grid 20mm 16 Gray 20mm
8 Arg. Grid 17 Trim Area
To Next Page
Loading...
