Ricoh M160 - Page 231

Updating the Firmware
SM 5-11 M160/M161
System
Maintenance
Code Meaning Solution
21 Not enough memory
for downloading
 Cycle the machine off/on.
 If you cannot resolve the problem with the above
steps, replace the controller board.
22 Cannot decompress
compressed data
 Cycle the machine off/on.
 Replace the SD card that was used to update
 If you cannot resolve the problem with the above
steps, replace the controller board.
24 SD card access error  Cycle the machine off/on.
 Make sure SD card inserted correctly, or use
another SD card.
 If you cannot resolve the problem with the above
steps, replace the controller board.
30 Cannot download
stamp data (no HDD)
 Connect HDD correctly.
 In the case of HDD failure, replace the HDD.
 Cannot be downloaded to a machine with no HDD.
32 Different SD card
between download
interruption and
download resumption
 Setting the SD card was interrupted. Cycle the
machine off/on.
 If the update cannot be made even if you insert the
correct SD card, there is a possibility that the SD
card is broken. Retry again with a different SD card.
 If you cannot resolve the problem with the above
steps, replace the controller board.
 If the program is in the SD card, reinsert the SD
card.
 If you updated engine, FCU, or operating unit,
replace each board.
33 Incorrect version data
in the SD card
 Acquire correct update data then install again.
34 Module error -
Correct module
(destination) is not in
the SD card.
 Acquire the correct data (Japan, Overseas, OEM,
etc.) then install again.