Maintenance
The approximate time it takes to transfer the debug log is as follows. Transfer time
may be affected by the type or format of the SD card. (It is recommended that you
format the SD card using the Panasonic SD Formatter (freeware)).
Controller debug log (GW debug log): 2 - 20 minutes
Engine debug log: 2 minutes
Operation panel debug log: 2 - 20 minutes
7. Make sure that the SD card access LED is off, then remove the SD card.
If ‘failed’ appears on the touch panel display, turn the power off, and then recover from
step 1 again.
The debug logs are saved with the following file names.
Controller debug log (GW
debug log)
/LogTrace/machine
number/watching/yyyymmdd_hhmmss_unique
identification number.gz
Engine debug log
/LogTrace/machine
number/engine/yyyymmdd_hhmmss.gz
Operation panel debug log
/LogTrace/machine
number/opepanel/yyyymmdd_hhmmss.tar.gz
To Next Page
Loading...
