SP Mode Tables
5118
[Disable Copying]
This program disables copying.
5-118-001 - C*
[0 or 1 / 0 / 1/step]
0: Not disabled
1: Disabled
5120
[Mode Clear Opt. Counter Removal]
Sets the mode clear operation in removal of counters to all the accounting
counter devices.
Sets whether to operate the mode clear or not when the accounting
devices released (e.g. no key-card, no remains in a card) before starting a
job or during idle after a job end.
If the accounting devices released during a job, the machine starts
canceling the job and then stops the counter. This SP, thus, is aimed to set
whether to do the mode clear operation if the stopped timing was during job
canceling.
5-120-001 0: Yes 1: StandBy 2: No C*
[0 to 2 / 0 / 1/step]
0: Yes (removed)
1: Standby (installed but not used)
2: No (not removed)
5121
[Counter Up Timing]
Determines whether the optional key counter counts up at paper feed-in or
at paper exit.
5-121-001 0:Feed 1:Exit C*
[0 or 1 / 0 / 1/step]
0: Feed
1: Exit
5127
[APS Mode]
Selects whether the APS function is enabled or disabled with the contact of
a pre-paid card or coin lock.
5-127-001 - C*
[0 or 1 / 0 / 1/step]
0: Not disabled
1: Disabled
To Next Page
Loading...
