Ricoh M160 - Page 593

Main SP Tables-8
M160/M161 3-180 SM Appendix
 Reading user stamp data is not counted.
 If a job is cancelled, the pages output as far as the cancellation are counted.
 If the scanner application scans and stores 3 B5 sheets and 1 A4 sheet, the S: count is 4.
 If pages are copied but not stored on the document server, these counters do not change.
 If both sides of 3 A4 sheets are copied and stored to the document server, the C: count is 6
and the L: count is 6.
 If you enter document server mode then scan 6 pages, the L: count is 6.
8221
[ADF Org Feeds]
These SPs count the number of pages fed through the ADF for front and
back side scanning.
8-221-001 Front C*
[0 to 9999999 / 0 / 1/step]
Number of front sides fed for scanning:
With an ADF that can scan both sides
simultaneously, the Front side count is
the same as the number of pages fed for
either simplex or duplex scanning.
With an ADF that cannot scan both sides
simultaneously, the Front side count is
the same as the number of pages fed for
duplex front side scanning. (The front
side is determined by which side the
user loads face-up.)
8-221-002 Back C*
[0 to 9999999 / 0 / 1/step]
Number of rear sides fed for scanning:
With an ADF that can scan both sides
simultaneously, the Back count is the
same as the number of pages fed for
duplex scanning.
With an ADF that cannot scan both sides
simultaneously, the Back count is the
same as the number of pages fed for
duplex rear-side scanning.
 When 1 sheet is fed for duplex scanning the Front count is 1 and the Back count is 1.
 If a jam occurs during the job, recovery processing is not counted to avoid double counting.
Also, the pages are not counted if the jam occurs before the first sheet is output.