Bit Switches - 1
SM 52 M160/M161 Fax Option
System Switch 04 (SP No. 1-101-005)
No Function Comments
0 Not used Do not change this setting.
3
Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (10
bytes each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are
printed (the other 24 bytes have no use for
service technicians).
5-7 Not used Do not change these settings.
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 (SP No. 1-101-010)
No Function Comments
0
Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
1
Print timing of communication
reports on the Journal when no
image data was exchanged.
0: After DCS/NSS
communication (default),
1: After polling
0: The Journal is printed only when image data
is sent.
1: The Journal is printed when any data is sent.
To Next Page
Loading...
