Memory Unit Type M1 1.5GB
M160/M161 2-50 SM
7. Insert the two left protrusions of the inner cover, and then insert the two right
protrusions into the notches on the machine.
8. Tighten the screw.
9. Attach the memory cover.
10. Plug in the power cord, and then turn on the machine.
11. Print the configuration page to confirm the installation (page 2-17 "Printing a
Configuration Page").
Confirm that the SDRAM module was correctly installed by printing the configuration
page. Check that the total memory value is shown in "Total Memory" on the configuration
page.
To Next Page
Loading...
