Specifying the Scan Settings
This section explains how to specify the scanning size, image density, and resolution for the current job.
When a scan destination is specified
When you specify a scan destination, the machine's scan settings change automatically according
to the information registered for that destination in the Address Book. If necessary, you can change
the scan settings for the current job using the control panel.
• The machine maintains the preset scan settings for the current destination until the machine returns
to standby mode.
• Changing the preset scan settings for the current destination does not change the information
registered in the Address Book.
• If you specify the last used destination, the preset scan settings become effective again, even if you
have changed the settings for the previous job.
Specifying the Scanning Size According to the Size of the Original
This section explains how to specify the scanning size according to the size of the current original.
1. Press the [Scanner] key.
2. Press [Addr].
3. Select [Search By Name] or [Search By ID].
4. Select the address to which you want to send the scanned document.
5. Press [Setting].
6. Press [Size].
7. Press the [ ] or [ ] key to select the size of the original, and then press the [OK] key.
If you selected anything other than [Custom Size], you do not need to perform the remaining steps
of the procedure.
5. Scanning Originals
108
To Next Page
Loading...
Need help?
General
