• If there are burrs on the edge of the paper when it is cut the surface on the leading edge of the
paper may come off. If this happens, turn over the paper or change the direction in which it is being
fed.
Loading Paper into Paper Trays
Every paper tray is loaded in the same way.
In the following example procedure, paper is loaded into Tray 1.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Check the paper edges are aligned at the right side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease or the paper may be
misfed.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This machine does not detect the paper size automatically.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
Loading Paper
61
To Next Page
Loading...
