Error and Status Messages on the Screen
Messages are listed in alphabetical order in the table below.
"X" indicates the parts of the messages that appear differently depending on the situation, such as the
paper size, paper type, and tray name.
• If the alert indicator lights up continuously or flashes, switch to copier mode and check the
displayed message.
Message Causes Solutions
ADF Orig. Misfeed
Open ADF Cover
and
Remove paper.
An original has been jammed
inside the ADF.
• Remove jammed originals, and then
place them again. See page 205
"Paper Feed Problems".
• Check the originals are suitable for
scanning. See page 73 "Placing
Originals".
Available: 2 Sided
Copy A4/LG/LT
2-sided copy could not be
performed because the tray
does not contain the valid size
paper, which are A4, Letter, or
Legal.
• Select the tray containing the A4, B5,
Letter, or Legal size paper (other than
the bypass tray) in the [Select Paper]
setting. See page 138 "Copier
Features Settings".
• Specify the A4, Legal, 16K size for
the tray selected for printing copies.
See page 145 "System Settings".
Unavailable Input
Tray
2-sided copy could not be
performed because paper is
specified to be fed from the
bypass tray.
Specify a setting other than [Bypass Tray]
for the [Select Paper] setting. See
page 138 "Copier Features Settings".
Available: IDCard
Copy A4/A5/
A6/8.5×11
ID card copy could not be
performed because the tray
does not contain the valid size
paper, which are A4, A5, A6,
8.5 × 11 size.
• Using the machine's control panel,
specify [Select Paper] to print copies
using the A4 or Letter size paper. See
page 138 "Copier Features Settings".
• Select the A4 or Letter size paper for
the tray selected for printing copies.
See page 145 "System Settings".
10. Troubleshooting
216