Copying an ID Card
1. Press the [ID Card Copy] key.
2. Place the original face down on the exposure glass. Align the original to the rear left
corner.
3. Press the [Start] key.
A message prompting you to place the original back side down on the exposure glass appears on
the display.
4. Place the original back side down and top to the machine rear on the exposure glass, and
then press the [Start] key again.
• After you load the originals, press the [Start] key within the time specified in [System Auto Reset
Timer]. Otherwise, the job is canceled. For details, see page 151 "Administrator Settings".
• Regardless of the machine's reduction or enlargement ratio setting, an ID card copy will always be
made at 100%.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed. For details, see page 151 "Administrator Settings".
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
4. Copying Originals
88
To Next Page
Loading...
