5. Align the end fence gently against the paper you loaded.
6. Carefully slide the paper tray fully in.
Loading Paper into Bypass Tray
Use the bypass tray to print onto OHP transparencies, thick paper, envelopes and copy paper that
cannot be loaded in the paper trays.
• Paper longer than 433 mm may become wrinkled, may not feed in, and may jam.
• Avoid using self-adhesive envelopes. They may cause machine malfunctions.
• Check there is no air in the envelopes before loading.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten their leading edges (the edge going into the machine) by running
a pencil or ruler across them.
• Some kinds of envelope might cause misfeeds, wrinkles or print poorly.
• Print quality on envelopes may be uneven if parts of an envelope have different thicknesses. Print
one or two envelopes in advance to check the print quality.
• In a hot and humid environment, the envelope might be delivered creased or with low printing
quality.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This machine does not detect the paper size automatically.
Loading Paper
63