Ricoh MP 2014 Series User Manual

Configuring the Network Settings
Click [Network Settings] to display the page for configuring the network settings.
This page contains the following tabs: [Network Status], [IPv6 Configuration], [Network Application],
[DNS], [Auto E-mail Notification], [SNMP], [SMTP], and [POP3].
• Depending on the settings you change, the machine might need to be restarted.
• Depending on the model you are using, some items might not appear.
Network Status Tab
General Status
Item Description
Ethernet Speed Shows the type and speed of the network connection.
IPP Printer Name Shows the name used to identify the machine on the network.
Network Version Shows the version of the machine's network module (a part of the machine
firmware).
Ethernet MAC Address Shows the Ethernet MAC address of the machine.
TCP/IP Status
Item Description
DHCP Select whether the machine should receive a dynamic IPv4 address
automatically using DHCP. To use DHCP, select [Active]. When enabled,
the items below cannot be configured.
IP Address Enter the IPv4 address for the machine.
Subnet Mask Enter the subnet mask of the network.
Gateway Enter the IPv4 address of the network gateway.
8. Configuring the Machine Using Web Image Monitor
172

Ricoh MP 2014 Series Specifications

General

Functions	Print, Copy, Scan
Print Technology	Laser
Print Speed	20 ppm
Print Resolution	600 x 600 dpi
Copy Speed	20 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Supported Paper Sizes	A3, A4, A5, B4, B5
Multiple Copy	Up to 99 copies
Duplex Printing	Manual
Interface	USB 2.0
Dimensions	587 x 581 x 461 mm
Type	All in One Printer
Standard Paper Capacity	250 sheets
Operating System Compatibility	Windows, Mac
First Print Out Time	Less than 10 seconds