Message Causes Solutions
Cannot copy.
Set original to ADF.
2-in-1, 4-in-1, or 2-sided copy
could not be performed
because the originals were not
placed in the ADF.
• Use the ADF, even when copying a
single sheet.
• If you need to use the exposure glass,
select [Off] or [Manual 2 Sided Scan
Mode] in [Duplex/Combine] under
copy settings, and then try again. See
page 138 "Copier Features Settings".
Check Paper Size The paper size set for the
document differs from the size of
the paper in the indicated tray.
Press [FormFeed] to begin printing, or
press [JobReset] to cancel the job.
Check Paper Type The paper type set for the
document differs from the type
of the paper in the indicated
tray.
Press [FormFeed] to begin printing, or
press [JobReset] to cancel the job.
Connection Failed The line could not be connected
correctly.
• Check if the telephone line cord is
properly connected to the machine.
• Disconnect the telephone line from
the machine, and connect the cord to
a telephone. Check if you can make
calls using the telephone. If you
cannot make calls this way, contact
your telephone company.
Cover open A cover is open. Close the cover completely.
Internal Misfeed Paper has been jammed in the
machine.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Misfeed: Dup. Unit
Remove Paper
Paper has been jammed in the
duplex unit.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Misfeed: Paper Tray Paper has been jammed in the
paper tray.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Misfeed: Stnd. Tray Paper has been jammed in the
paper exit area.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Misfeed: Tray 1 Paper has been jammed in the
Tray 1 paper input area.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Error and Status Messages on the Screen
217
To Next Page
Loading...
Need help?
General
