Message Causes Solutions
Misfeed: Tray 2 Paper has been jammed in the
Tray 2 paper input area.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Misfeed: Tray 3 Paper has been jammed in the
Tray 3 paper input area.
Remove the jammed paper. See page 205
"Paper Feed Problems".
Net Communication
Error
Connection with the server was
lost while sending or receiving
data.
Contact the network administrator.
Out of Paper: X The indicated tray has run out of
paper.
Load paper to the indicated tray. See
page 60 "Loading Paper".
Please Restart
Machine
The machine needs to be
restarted.
Turn off the power, and then turn it back
on.
Replace IntTrans. Belt The transfer belt is no longer
usable, and must be replaced.
Contact your sales or service
representative.
Replace Required
Soon:
Print Cartridge
The print cartridge is almost
empty.
Prepare a new print cartridge.
Scan (NW)
Disconnected
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Reconnect the Ethernet cable properly,
and then try the operation again.
Scan (USB)
Disconnected
The USB cable was
disconnected while scanning
from a computer.
Reconnect the USB cable properly, and
then try the operation again.
Server Connection
Failed
A scanned file could not be sent
because the destination could
not be reached.
Check if the destination is registered
correctly, and then try the operation again.
Server Response
Error
An error occurred in
communication with the server
before beginning transmission.
Check if the destination is registered
correctly, and then try the operation again.
If the problem persists, contact the network
administrator.
Service call - SCXXX A fatal hardware error has
occurred, and the machine
cannot function.
Contact your sales or service
representative.
10. Troubleshooting
218
To Next Page
Loading...
