Rigol HDO1000 Series User Manual

label at the top of the screen, as shown in the figure below. The information will
change based on the trigger settings.
Source Setting
• Source A:
Click or tap the drop-down button of SourceA to select CH1-CH4. For details,
refer to Trigger Source . The selected trigger source is indicated in the trigger
information label at the top of the screen.
Only when you select the channel that has signal inputs as the trigger source,
can you obtain a stable trigger.
• Edge A:
Select the trigger edge type ("Rising" or "Falling") of Source A in Delay trigger in
the
EdgeA item.
• Source B:
Click or tap the drop-down button of
SourceB to select CH1-CH4. For details,
refer to Trigger Source . The selected trigger source is indicated in the trigger
information label at the top of the screen.
Only when you select the channel that has signal inputs as the trigger source,
can you obtain a stable trigger.
• Edge B:
Select the trigger edge type ("Rising" or "Falling") of Source B in Delay trigger in
the
EdgeB item.
Set the trigger condition
Sets the time limit condition of Delay trigger in the
When item.
• >: triggers when the time difference (∆T) between the specified edges of Source
A and Source B is greater than the preset time lower limit. Click or tap the input
field of
Lower to set the delay time lower limit in Delay trigger with the pop-up
numeric keypad. You can also use the corresponding multipurpose knob to set
the value.
• <: triggers when the time difference (∆T) between the specified edges of Source
A and Source B is smaller than the preset time upper limit. Click or tap the input
field of
Upper to set the delay time upper limit in Delay trigger with the pop-up
numeric keypad. You can also use the corresponding multipurpose knob to set
the value.
Triggering the Oscilloscope
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
HDO1000 User Guide
91

Rigol HDO1000 Series Specifications

General

Brand	Rigol
Model	HDO1000 Series
Category	Test Equipment
Language	English