Rigol HDO1000 Series

Figure 14.15 LIN Decoding Event Table
TIP
• When you adjust the horizontal time base, the waveform displayed on the screen will also
change, and the total number of lines containing the decoding information in the event
table will also be changed.
• The displayed decoded data information in the bus is related to the value of the
horizontal time base. Reducing the horizontal time base can help you view the detailed
information.
Set the Event Table Format
In the Decode menu, click or tap the drop-down button of Format to select the
display format of "Data" in the event table. The available options include "Hex",
"Dec", "Bin", or "ASCII".
Interpret the Decoded LIN Data
• Break (Sync Break): expressed in Hex, identified as "Break:".
• SYNC (Sync): expressed in Hex, identified as "SYNC:".
• ID (Frame ID): expressed in Hex, identified as "ID:".
• Data (Data): Its display format is the same as that of the bus data (Hex, Dec, Bin,
or ASCII), identified as "Data:".
• CRC (Cyclic Redundancy Check): expressed in Hex, identified as "CRC:". When
errors occur, it is displayed as a red patch for the checksum error.
• Wakeup (wake up symbol): identified as "Wakeup:".
Protocol Decoding
HDO1000 User Guide
190
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.