YES: Enables communication with the monitoring station to report alarms, trouble, and
supervisory events.
NO: No communication with the Monitoring Station is possible. Choose NO for
installations that are NOT monitored by a Monitoring Station.
Configuration Software Enable YES
YES: Enables communication between the alarm company and the system using the
Configuration Software. This enables modifying an installation's configuration, obtaining
status information, and issuing main panel commands, all from a remote location.
NO: Disables communication, as detailed above.
YES: Enables Follow-Me communication.
If both the monitoring station phones and the Follow Me phones are defined, the system
will first call the monitoring station phones and then the Follow Me phones.
NO: Disables Follow-Me communication.
Yes: Enables communication between the WiComm Pro system and the RISCO Cloud
server.
NO: Does not enable communication, as detailed above.
This option limits the installer authorization to access the Programming menu.
YES: A Grand Master code is required to authorize the installer to enter the
Programming mode for 1 hour.
NO: The installer does not need an authorization code.
Specifies if the system/partition can be armed when there is a fault in the system.
YES: The system will arm even if there is a fault in the system.
NO: When the user starts the arming process and there is a system-fault, the user must
confirm that he is aware of all faults before continuing with the arming process.
This is done via the User menu > Activities >Bypass Trouble.
The system will not arm during forced arming if a fault occurred in the system.
To Next Page
Loading...
