Risco RW332M - Page 65

Page 59
Zones: Parameters
Parameter
Default
Range
Specifies the number of images to be captured when an alarm event occurs.
Image Interval
1.0
0.5, 1.0, and
2 seconds
Specifies the time in between image captures.
Image Pre- Alarm
YES
YES/NO
Specifies if an image capture is to be performed upon each System Away
arming. The picture is sent only in the event of an alarm occurrence, together
with the alarm images.
Image Resolution
QVGA
QVGA (320X240)
VGA (640X480)
Specifies image quality, as defined by pixel resolution. A QVGA image file is
approximately 7 Kb and VGA image file is 18 Kb
Image Quality
High
High/Low
Specifies the extent of jpeg image lossy compression (Low=more
compression, smaller file size; High=less compression, larger file size)
Colored Image
YES
YES/NO
Specifies whether the captured and transmitted photographic image is to be
color or black and white.
X73 Parameters
This section refers to the programming options of the two-way magnetic contact
RWX73M and RWX73F. The programming options
RWX73 M Parameters
The RWX73M is a 2-way supervised transmitter that combines Magnetic/Door
contact against opening doors and windows with additional universal input.
The RWX73M operates with RISCO Group 2-Way wireless systems
Magnet
Enable
Enable/Disable
Enable or disable the transmitter’s magnet.
Alarm Hold
On
On
On/Off
Use this parameter to define the minimum period between alarm broadcasts.
ON: Only one alarm message is transmitted in any 2.5 minute time-period
OFF: Alarm detection is immediately transmitted