Define here the number of pulses for the input.
RWX73 F Parameters (Universal mode)
The RWX73F is a 2-way multi-function supervised transmitter with two separate
channels that combines Magnetic/Door contact (universal).
The RWX73F has two reed switches for protection against opening doors and
windows, and against any attempt to tamper the detector using large magnets.
The RWX73F operates with RISCO Group 2-Way wireless systems
Enable or disable the transmitter’s magnet.
Use this parameter to define the minimum period between alarm broadcasts.
ON: Only one alarm message is transmitted in any 2.5 minute time-period
OFF: Alarm detection is immediately transmitted
Input 1 Termination
(External Zone):
Use this parameter to program the connection type used for Input 2.
N/O: Uses normally-open contacts and no terminating End-of-Line Resistor.
N/C: Uses normally-closed contacts and no terminating End-of-Line Resistor.
DEOL: Uses normally-closed (NC) contacts in a zone using two 10 KΩ of
End-of-Line Resistors to distinguish between alarms and tamper conditions.
Set the duration for which a zone violation must exist in order for the zone to
trigger an alarm condition.
Enable or disable the transmitter’s anti-sabotage magnet.
Two-way Smoke Detector Parameters
Set operation mode of the two-way smoke detector (model RWX34S):
⬧ Smoke Only: Smoke alarm only
⬧ Heat Only: Heat alarm only
⬧ Smoke + Heat: Smoke or heat alarm
To Next Page
Loading...
