I/O Expander: Output Parameters
Activates the utility output when all the selected partition(s) are
in the Ready state.
Activates the utility output when the selected partition(s) is armed in Away
(Full Arm) mode. The utility output will be activated immediately, regardless
of the Exit Delay time period.
Activates the utility output Utility Output when the selected partition(s) is
disarmed.
Activates the utility output Utility Output when an alarm occurs in the selected
partition(s).
Activates the utility output when an intrusion (Burglary) alarm occurs in the
selected partition(s).
Activates the utility output when a fire alarm is triggered in the selected
partition(s) from the keypads or a zone defined as Fire.
Activates the utility output when a panic alarm is triggered in the selected
partition(s) from the keypads, remote controls or a zone defined as Panic.
Activates the utility output when a special alarm is triggered in the selected
partition(s) from the keypads or a zone defined as Special .
Activates the Utility Output when the selected partition(s) initiates an
Exit/Entry Delay period.
Activates the utility output Utility Output when the relevant partitions are in
ARM or STAY (Partial Arm) mode and any zone in the relevant partitions is
bypassed.
Activates the utility output when there is a not ready zone at the end of the
pre- warning time during an auto-arm process. The output restore shall be on
Bell-Timeout or at user Disarm.
To Next Page
Loading...
