I/O Expander: Output Parameters
Activates the utility output when there is a lost wireless zone in the system.
The output restore shall be on Bell-Timeout or at user Disarm.
Activates the utility output Utility Output when the selected partition(s) is
armed in Stay mode.
Activates the utility output Utility Output following a chime sound in the
selected partition(s)
This parameter causes the utility output to function as follows:
⬧ In Away arming mode, the utility output will follow the bell
activation in the defined partitions.
In Stay Arm (Partial Arm) mode, the utility output will not be activated.
⬧ Activates the utility output when one of the defined partitions is in
Alarm mode and the bell is triggered. This enables the connection of
different sirens to different partitions.
Activates the utility output when an event of NO ACTIVITY occurs in the
system. . The No Activity function is for reception of signals used to monitor
the activity of sick, elderly or disabled people
Activates the utility output when a confirmed alarm occurs in the system.
Activates the utility output when the selected zone is
tripped.
The tripped zone need not be armed to trigger the Utility Output.
Activates the utility output when the selected zone causes an alarm.
Activates the utility output when the selected zones are armed.
To Next Page
Loading...
