Allows to control timers related to operation with the GSM.
The Caller ID function enables to restrict SMS remote control operations to the
predefined Follow Me phone numbers. If the incoming number is recognized as
one of the Follow Me numbers, the operation will be executed.
YES: The system will disable the GSM/GPRS from any activity.
NO: GSM/GPRS is enabled in the system.
CS via GPRS (out) YES NO/YES
YES: Enables to connect the panel to remote Configuration Software via the
GPRS channel. The connection can be established either from the LCD keypad
(Installer Menu > Activities > 7)CS Connect > 2)Via GPRS) or via SMS request
command from the Configuration Software.
NO: Communication between the Configuration Software and the panel via
GPRS is disabled
CS via GPRS (Listener mode) NO NO/YES
YES: Configuration Software can attempt to contact the panel through the GSM
CSD channel.
NO: Configuration Software cannot attempt to contact the panel through the
GSM CSD channel
Allows to program timers related to the operation with the GSM module.
The PIN (Personal Identity Number) code is a 4 to 8 digit number giving you
access to the GSM network provider.
Note: You can cancel the PIN code request function by inserting the SIM card into a regular
mobile phone and according to the phone settings, disable this function.
A telephone number of the message delivery center. This number can be
obtained from the network operator.
To Next Page
Loading...
