Risco RW332M - IP Communication Configuration

Page 90
Communication Type: IP
Parameter
Default
Range
IP Configuration
Obtain Automatic IP
Dynamic IP
Dynamic IP/Static IP
Defines whether the IP address, which the WiComm Pro refers to, is static or
dynamic.
Dynamic IP: The system refers to an IP address provided by the DHCP.
Static IP: The system refers to a static IP Address.
Panel Port
01000
Enter the WiComm Pro Port address.
IP Address
Enter the WiComm Pro IP address.
Subnet Mask
The subnet mask is used to determine where the network number in an IP
address ends.
Gateway IP
The IP address of the local Gateway, which enables communication settings to
other LAN segments. This address is the IP address of the router connected to
the same LAN segment as the WiComm Pro.
DNS Primary
The IP address of the primary DNS server on the network.
DNS Secondary
The IP address of the secondary DNS server on the network
Scan WiFi Net
The Control panel scans for Wi-Fi networks and shortly after available
networks appear in a list (the connected network is marked and appears first in
the list). The rest of the list is sorted from high RSSI to low, with a max. 20
networks.
Scroll to your Router’s Wi-Fi network, select the desired network and then
press [enter].
Enter the Password, if required, and press [enter]. If connection is successful, a
successful message is displayed. If there is a connection failu
re, an error message is displayed
Add WiFi Net
Add Wi-Fi Network
WPS (Button)