Rohde & Schwarz FSW26 - Page 1012

Remote Commands
R&S
®
FSW
1012User Manual 1173.9411.02 ─ 19
Useful commands for storing results described elsewhere:
● FORMat[:DATA] on page 921
Remote commands exclusive to storing results:
FORMat:DEXPort:HEADer............................................................................................1012
FORMat:DEXPort:TRACes........................................................................................... 1012
MMEMory:STORe:LIST................................................................................................1013
MMEMory:STORe:PEAK.............................................................................................. 1013
MMEMory:STORe<n>:SGRam......................................................................................1014
MMEMory:STORe:SPURious........................................................................................1014
MMEMory:STORe<n>:TRACe.......................................................................................1015
FORMat:DEXPort:HEADer <State>
If enabled, additional instrument and measurement settings are included in the header
of the export file for result data. If disabled, only the pure result data from the selected
traces and tables is exported.
See chapter 8.4.4, "Reference: ASCII File Export Format", on page 557 for details.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Usage: SCPI confirmed
Manual operation: See "Include Instrument Measurement Settings" on page 471
FORMat:DEXPort:TRACes <Selection>
This command selects the data to be included in a data export file (see MMEMory:
STORe<n>:TRACe on page 1015).
For details on exporting data see chapter 7.3.2.3, "Trace / Data Export Configuration",
on page 470.
Parameters:
<Selection> SINGle
Only a single trace is selected for export, namely the one speci-
fied by the MMEMory:STORe<n>:TRACe command.
ALL
Selects all active traces and result tables (e.g. Result Summary,
marker peak list etc.) in the current application for export to an
ASCII file.
The <trace> parameter for the MMEMory:STORe<n>:TRACe
command is ignored.
*RST: SINGle
Usage: SCPI confirmed
Manual operation: See "Export all Traces and all Table Results" on page 471
Managing Settings and Results