Common Analysis and Display Functions
R&S
®
FSW
528User Manual 1173.9411.02 ─ 19
7.5.3.1 Display Line Settings
Two vertical and two horizontal lines can be defined in the display.
Vertical Line 1/2.......................................................................................................... 528
Horizontal Line 1/2...................................................................................................... 528
Vertical Line 1/2
Activates a vertical display line (F1/F2 or T1/T2) in the diagram at the specified fre-
quency or point in time, depending on the frequency span.
Remote command:
CALCulate<n>:FLINe<k> on page 976
CALCulate<n>:FLINe<k> on page 976
CALCulate<n>:TLINe<Line> on page 977
CALCulate<n>:TLINe<Line> on page 977
Horizontal Line 1/2
Activates a horizontal display line (D1/D2) in the diagram at the specified level.
Remote command:
CALCulate<n>:DLINe<k> on page 975
CALCulate<n>:DLINe<k> on page 975
7.5.3.2 Limit Line Settings and Functions
Up to 8 limit lines can be displayed simultaneously in the R&S FSW. Many more can
be stored on the instrument.
Limit Line Management...............................................................................................528
Limit Line Details.........................................................................................................531
Limit Line Management
Limit lines are managed in the "Line Config" dialog box which is displayed when you
press the LINES key and then "Lines Config" softkey.
Display and Limit Lines
To Next Page
Loading...
