Rohde & Schwarz FSW26 - Page 869

Remote Commands
R&S
®
FSW
869User Manual 1173.9411.02 ─ 19
Manual operation: See "Bias Settings" on page 371
[SENSe:]MIXer:LOPower <Level>
This command specifies the LO level of the external mixer's LO port.
Parameters:
<Level> numeric value
Range: 13.0 dBm to 17.0 dBm
Increment: 0.1 dB
*RST: 15.5 dBm
Example:
MIX:LOP 16.0dBm
Manual operation: See "LO Level" on page 370
[SENSe:]MIXer:SIGNal <State>
This command specifies whether automatic signal detection is active or not.
Note that automatic signal identification is only available for measurements that per-
form frequency sweeps (not in vector signal analysis or the I/Q Analyzer, for instance).
Parameters:
<State> OFF | ON | AUTO | ALL
OFF
No automatic signal detection is active.
ON
Automatic signal detection (Signal ID) is active.
AUTO
Automatic signal detection (Auto ID) is active.
ALL
Both automatic signal detection functions (Signal ID+Auto ID)
are active.
*RST: OFF
Manual operation: See "Signal ID" on page 371
See "Auto ID" on page 371
[SENSe:]MIXer:THReshold <Value>
This command defines the maximum permissible level difference between test sweep
and reference sweep to be corrected during automatic comparison (see [SENSe:
]MIXer:SIGNal on page 869).
Parameters:
<Value> <numeric value>
Range: 0.1 dB to 100 dB
*RST: 10 dB
Example:
MIX:PORT 3
Setting Basic Measurement Parameters