Rohde & Schwarz SML01 - Page 117

R&S®SML / R&S®SMV03 Stereo Modulation (Option R&S SML-B5)
1090.3123.12 4.39 E-6
TP
Description: Sets or reads the traffic program flag.
This flag signals whether traffic information is generally transmitted.
Command: TP=x
Query: TP?
Response: x
Value range: 0|1
Example: Command:
STEReo:DIRect „TP=1“
The traffic program flag is set to "1".
Query:
STEReo:DIRect? “TP“
Response:
"1"
TRANS
Description: Transparent mode
An RDS data stream of binary data is generated.
(If transparent data is selected, all other RDS data is ignored.)
Command: TRANS= xxxxxxxxxxxxxxxx,...
Query: TRANS?
Response: xxxxxxxxxxxxxxxx,...
Value range: x = 16 ASCII coded hexadecimal characters (blocks A to D of the RDS groups)
TRANS=0: Deletes all transparent data and switches back to normal RDS data
transmission.
Max. 20 different data sequences can be defined.
Example: Command:
STEReo:DIRect “TRANS=0123456789ABCDEF“
The data "0123456789ABCDEF" is sent instead of the RDS data.
Query:
STEReo:DIRect? “TRANS“
Reads the transparent data.
Response:
"0123456789ABCDEF"
Note: 16 characters must be specified for each data sequence. Leading zeros, if any, must also
be specified. The data will be transmitted even if it constitutes no meaningful RDS data.