R&S®SML / R&S®SMV03 SOURce:STEReo
1090.3123.12 E-6 6.35
[:SOURce]:STEReo:ARI
The c
ommands to set the ARI functions are under this node.
[:SOURce]:StEReo:ARI:BK[:CODE] A | Bl | C | D | E | F
The command selects the standard traffic area codes A to F.
Example: :SOUR:STER:ARI BK F *RST value A
[:SOURce]:STEReo:ARI[:DEViation] 0 to 10 kHz
Input value of the frequency deviation of the ARI subcarrier.
Example: :SOUR:STER:ARI 4 kHz *RST value is 3.5 kHz
[:SOURce]:STEReo:ARI:STATe ON | OFF
Switching on/off ARI subcarrier.
Example: :SOUR:STER:ARI:STAT ON *RST value is OFF
[:SOURce]:STEReo:TYPE: DK | BK | BKDK
Selection of ARI broadcasting code (DK) and ARI area code (BK).
DK Broadcasting code is selected
BK Area code is selected
BKDK Broadcasting code and area code are selected
Example: :SOUR:STER:TYPE:BKDK *RST value is DK
[:SOURce]:STEReo:ARI:TYPE:STATe ON | OFF
Switching on/off ARI area code and braodcasting code.
Example: :SOUR:STER:ARI:STAT ON *RST value is OFF
[:SOURce]:STEReo:AUDio
The commands to set the frequency of LF generator, the operating mode (L, R, L=R, L=-R, LR)
and the prempasis are under this node. Unter diesem Knoten befinden sich die
[:SOURce]:STEReo:AUDio:MODE LEFT | RIGHt | RELeft | REMLeft| RNELeft
Selection of the operating mode
LEFT Audio signal only in the left-hand channel
RIGHt Audio signal only in the right-hand channel
RELeft Audio signals of same frequency and phase in both channels.
REMLeft Audio signals of same frequency but opposite phase in both channels
RNELeft Different and independent audio signals in both channels
(not possible with internal LG generator).
Example: :SOUR:STER:AUD:MODE REL *RST value is REL
To Next Page
Loading...
