Rohde & Schwarz SML01 - Page 214

SOURce:STEReo R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.36
[:SOURce]:STEReo:AUDio[:FREQency] 0.1 H
z to 1 MHz
Input value of the frequency of the LF generator.
Example: :SOUR:STER:AUD 3 kHz *RST value is 1 kHz
[:SOURce]:STEReo:AUDio:PREemphasis 50 us | 75 us
Selection of the preemphasis.
Example: :SOUR:STER:AUD:PRE 75 us *RST value is 50 us
[:SOURce]:STEReo:AUDio:PREemphasis:STATe ON | OFF
Switching on/of preemphasis.
Example: :SOUR:STER:AUD:PRE:STAT ON *RST value is OFF
[:SOURce]:STEReo:EXTernal:IMPedance 600 Ohm | 100 kOhm
Selection of the input impedances of the analog audio inputs l and R. Both input impedances are
switched simultaneously
Example: :SOUR:STER:EXT:IMP 600 Ohm *RST value is 100 kOhm
[:SOURce]:STEReo[:DEViation] 0 to 80 kHz
Setting value the frequency deviation of the stereo signal.
Example: :SOUR:STER 50 kHz *RST value is 40 kHz
[:SOURce]:STEReo:DIRect 'String'
Command to send the RDS setting strings to the RDS /Stereo coder.
Example: :SOUR:STER:DIR 'String'
[:SOURce]:STEReo:PILot
Commands for pilot tone settings are under this node.
[:SOURce]:STEReo:PILot[:DEViation] 0 to 10 kHz
Setting value of the frequency deviation of the pilot tone.
Example: :SOUR:STER:PIL 5 kHz *RST value is 6.75 kHz
[:SOURce]:STEReo:PILot:PHAse -5 to 5 DEG
Setting value of phase of the pilot tone.
Example: :SOUR:STER:PIL:PHA 3 DEG *RST value is 0 DEG
[:SOURce]:STEReo:PILot:STATe ON | OFF
Switching on/off the pilot tone.
Example: :SOUR:STER:PIL:STAT ON *RST value is OFF