Rohde & Schwarz SMW-K144 - Page 217

Remote-Control Commands
R&S
®
SMW-K144
217User Manual 1178.8013.02 ─ 06
Parameters:
<UserAllocRBNum> integer
CORESET allocations span always a multiple of 6 resource
blocks. Thus, only values that are multiple of 6 are allowed for
these allocations.
The number of resource blocks that are available for PUSCH
depends on whether the transform precoding is enabled or not
(that is if DFT-s-OFDM is applied), see [:SOURce<hw>]:BB:
NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:TPSTate.
Query the number of resource blocks used by PRACH with the
command [:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:
SUBF<st0>:USER<dir0>:BWPart<gr0>:ALLoc<user0>:
PRACh:RBNumber?.
Range:
20 to 275
*RST: 20
Example: See Example "Configuring the configurable allocations in the
users and BWPs groups" on page 152.
Manual operation: See "No. RB" on page 85
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:RBNumber?
Queries the number of resource blocks the PRACH allocation spans.
Return values:
<UserAllocRBNum> integer
Range: 3 to 24
*RST: 12
Example: See Example "Configuring the PRACH settings" on page 161.
Usage: Query only
Manual operation: See "No. RB" on page 85
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:RBOFfset <RbOff>
Adds a frequency offset and sets the start resource block of the selected allocation.
Parameters:
<RbOff> integer
Range: 0 to 255
*RST: 0
Example: See Example "Configuring the configurable allocations in the
users and BWPs groups" on page 152.
Manual operation: See "Offs. RB" on page 85
Scheduling Commands