7—Project and Drive Operations
Roland VS-2000 Owner’s Manual www.RolandUS.com 111
11. Insert the requested media and press ENTER/YES, or press EXIT/NO to abort the
procedure.
12. If you’re backing up multiple projects, the VS-2000 backs up each one in turn.
RECOVER
To re-load VS-2000 project backup data, use the RECOVER operation. When you
recover a project, the project is restored to your internal hard drive in its original state.
Recovering Backup Data
1. Hold down SHIFT and press F1 (PROJECT).
2. Insert the CD containing the backup into your CD-R/RW drive.
3. Select the drive containing the project backup data.
4. Press F6 (LIST) to view the drive’s contents. The VS-2000 displays:
5. Press ENTER/YES to continue, or EXIT/NO to cancel the drive change.
6. Mark the project(s) you want to recover.
7. Turn the Time/Value dial to select the drive to which you want to recover the
marked backup data.
8. If “Recovr” isn’t visible above F2, press PAGE until it is.
9. Press F2 (Recovr)—the PROJECT RECOVER screen appears.
10. Set Erase all Projects to:
•
Off
—if you want to add the project(s) you’re recovering to the list of projects
already on the destination drive.
•
On
—if you want to clear the drive so it contains only your recovered projects.
11. Set the desired CD drive speed. Try MAX. If you experience problems recovering
the data, try a lower speed.
12. Press F5 (OK). The VS-2000 asks if you want to save the currently loaded project.
13. Press ENTER/YES to save the loaded project before the recovery operation, or
press EXIT/NO to go straight to recovery.
Project backup data cannot be played as is. To play the project, use project RECOVER to
restore the project to your hard drive in playable form.
RECOVER is available only when the selected drive contains project backup data.
If the project is backed up on more than one disk, insert the first
disk containing backup data.
New drive’s
name
List of project
backup data
you’ve marked
Drive
containing
backup
Drive to which
data will be
recovered
Press F2 to scroll down
through the list of
project backup data if it
extends out of view, or
F1 (Scrol) to scroll up
through the list.
VS2000OMUS.book 111 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
