13—Operating the Hard Disk Recorder
Roland VS-2000 Owner’s Manual www.RolandUS.com 185
Turning on Locator Safe Mode
1. Hold down SHIFT and press F4.
2. If “SYSTEM” doesn’t appear above F1, press PAGE until it does.
3. Press F1 (SYSTEM).
4. The LOCATOR/SCENE TYPE parameter turns Safe mode on or off—see Page 379.
Its default value is Quick. To turn on Safe mode, select Safe.
Recalling a Locator in Safe Mode
1. Press LOCATOR•SCENE so it lights green—the
LOCATOR window opens.
2. Turn the Time/Value dial to highlight the desired
locator.
3. Press ENTER/YES to recall the selected locator and
close the window, or just press ENTER/NO twice to
leave the window without recalling a locator.
Storing a Locator in Safe Mode
1. Position the now line at the desired location on the
project.
2. Press LOCATOR•SCENE so it lights green—the
LOCATOR window appears.
3. Turn the Time/Value dial to select the desired unused
locator slot.
4. Press ENTER/YES to store the now line’s current
position as a new locator and close the window, or just press EXIT/NO twice to
leave the window without registering the locator.
Clearing a Locator in Safe Mode
1. Press LOCATOR•SCENE so it lights green—the
LOCATOR window appears.
2. Turn the Time/Value dial to select the desired locator.
3. Press CLEAR—“Clear Locator?” appears.
4. Press ENTER/YES to clear the selected locator and
close the window, or just press EXIT/NO three times
to leave the window without clearing the locator.
VS2000OMUS.book 185 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
