Roland VS-2000 - 13 Operating the Hard Disk Recorder; The Transport Buttons; Special Transport Buttons; The Main Transport Buttons

Roland VS-2000 Owner’s Manual www.RolandUS.com 175
13—Operating the Hard Disk Recorder
This chapter discusses the mechanics of using the VS-2000’s hard disk recorder—
basically, it’s all about recording and playing back a project. We’ll describe the
recorder’s tools for navigating a project and for playing it back in a variety of ways.
The Transport Buttons
The Main Transport Buttons
The most basic tools you have for recording and playing a project—and running the
hard disk recorder—are the transport buttons.
Special Transport Buttons
In addition to the main transport buttons, you can jump to the:
• the beginning, or “top,” of the project’s audio —by holding down SHIFT
and pressing REW.
• the end of the project’s recorded audio —by holding down SHIFT and
pressing FF.
If you’re not clear on what the hard disk recorder is and what it does, see “The Hard
Disk Recorder” on Page 56. To learn the fundamentals of how it records and plays back
audio—and how its built-in hard disk works—see Chapter 6, starting on Page 93.
You can reverse any recording action using the VS-2000’s Undo and Redo features,
described on Page 72.
Press: To:
PLAY begin playback from the now line’s current position in the project.
STOP halt playback at the now line’s current position.
REC begin recording any armed tracks, as described on Page 177.
ZERO return to Time 00h00m00s00f00, the very beginning of the project.
REW move back in time through the project
FF move forward in time through the project
The buttons perform other tasks when SHIFT is held down. See “SHIFT Operations”
on Page 399.
+
+
VS2000OMUS.book 175 ページ ２００４年１０月２０日 水曜日 午後３時３分