10—Using the Digital Mixer
Roland VS-2000 Owner’s Manual www.RolandUS.com 143
Basic Scene Operations
You can quickly and easily store and recall scenes using LOCATOR•SCENE
button.
Storing a Scene
1. Hold down SHIFT and press LOCATOR•SCENE so it lights red.
Each scene is stored in a numbered location from 1 to 16,
corresponding to the 16 TRACK/STATUS buttons. When a scene has been stored in
a location, the corresponding TRACK/STATUS button is lights in Scene mode.
2. Press any TRACK/STATUS button to store the scene in the corresponding location.
If you’d like to store the scene in a different scene bank, follow the instructions in
“Changing Scene Banks” and press its button in the selected bank.
3. If a location already contains a scene, and you’d like to store a new scene in its
place, you’ll have to clear the older scene first. See “Clearing a Scene” on Page 143.
Recalling a Scene
1. Hold down SHIFT and press LOCATOR•SCENE if it’s not already lit red.
2. If the current scene bank contains the scene you want, press the scene’s lit TRACK/
STATUS button. To recall a scene from a different bank, follow the instructions in
“Changing Scene Banks” and then press the scene’s button in the desired bank.
Changing Scene Banks
1. Hold down SHIFT and press LOCATOR•SCENE if it’s not already lit red. If any
scenes are stored in the currently selected scene bank, their TRACK/STATUS
buttons light.
2. While holding down SHIFT, hold down LOCATOR•SCENE for two seconds—the
SCENE BANK SELECT window pops open.
3. Turn the Time Value dial to select the desired scene bank and press ENTER/YES.
Clearing a Scene
1. Hold down SHIFT and press LOCATOR•SCENE if it’s not already lit red. If you’d
like to clear a scene from a different bank, see the instructions in “Changing Scene
Banks” before proceeding.
2. While holding down CLEAR, press the desired scene’s TRACK/STATUS button.
The scene is cleared from that location, and the button’s light turns off.
Leaving Scene Mode
To leave Scene more manually, press LOCATOR•SCENE so its light turns off.
After you store or recall a scene, the VS-2000 returns the TRACK/STATUS buttons to
their normal job of controlling hard disk recorder tracks (Page 176)—this is intended to
Scenes can be stored and recalled only when a project isn’t currently playing.
You can also store and recall scenes from the UTILITY menu (Page 144).
You can use the Scene feature’s Safe mode, and perform scene operations more
carefully and slowly from a list in the SCENE window. See Page 145.
+
VS2000OMUS.book 143 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
